Summary Works with cone joint papers. I just used a piece of filament to connect the pouring cone; stuck it through, melted the ends. This is more novelty than functional, but it does work. You need to grind your stuff very small to powder and add it slowly so it doesn't clog the cone. To get the cone to slide up and down the shaft (heh heh) properly I melted the cone holders end and pinched it a little so it grabs the barbs on the shaft. I just melted the end of the shaft and pressed it into the base. Print Settings Printer: M3D Rafts: Doesn't Matter Supports: Doesn't Matter Notes: I broke the pieces apart and printed them individually. Some need supports, some don't. etc. I printed the cone on it's side.