Summary A simple filament guide that I made to mount to my wall/ceiling in my office. The old guide tended to bind the filament from time to time. Made mount with counter sunk screw holes, but just used command strips on my, at least for now. The print in the photos is pretty bad, but it was made when I had binding issues. The model its self is clean. Print Settings Printer: Prusa I3 variant Rafts: Doesn't Matter Supports: Doesn't Matter Notes: I used 2 sheels with 30% infill. Not sure it matters with in reason though. How I Designed This Used Fusion 360 to design. This was needed as my current guide was binding and causing print issues.