This figure of an astronaut I made especially for the Space Design Contest.

The figure must be assembled and have a battery, switch, connector and the LED with the resistor inside.

I tried to make a figure in such a way that the battery can be replaced quite easily.

To completely make this figure, you will need the ability to solder, basic knowledge of electronics and these items:

1) Battery CR2032 with the connectors - 1pc.

2) Switch SS-12D01 (or simular with same size) - 1pc.

3) PBS-3 connector - 1pc.

4) 3mm LED (yellow glow) - 1pc.

5) Resistor at 400-500 ohm - 1pc.

6) A bit of thin wire.

7) Superglue.

8) The soldering iron and solder.

You can download assembly.docx file to understand how to assemble this figure.