Even with 1/4, 1/2, and full-length sections of track, I kept running into issues where I couldn't quite balance out multiple Japanese Plarail track sections. There were awkward bends. So, I sat down with a caliper, drew out a section in Inventor, exported as STL, ran it through Cura (had to rotate to lay them flat), and printed it in PLA. Fit perfect on the first try! Beginner's luck, I think.
Two versions, the first about 10mm shorter than a stock 1/4 length segment, and the other about 20mm.
Loading prints...
Tomy Plarail Train Track, Short Straight
1
like
1
collection
Tags:
Creative Commons Attribution-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given and your contributions are under the same license.
Licensed under CC BY-SA
Files Included
2 downloadable files:
Free download - login required
Downloaded: 135 times
Downloaded: 135 times
Loading comments...