Use this to convert 2 pieces of 20cm IKEA BLANDA serving bowl into a nice spherical glass terrarium.
Printed without support at 0.2mm layer height, infill irrelevant. Each piece is a 40º revolution from the circular center. So theoretically you will need 9 pieces to fully go around the bowl. As it turned out for me, I had to trim down the last piece so it'll fit (as shown in one of the photos). Yours may vary depending on your print. FreeCAD source file available here if you want to change the revolution angle, or anything else.
The decorative 3D printed sitting fox is by steven_dakh and is available here.
Happy terrarium gardening!
Loading prints...
IKEA BLANDA 20cm Serving Bowl Terrarium
Creative Commons Attribution-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given and your contributions are under the same license.
Licensed under CC BY-SA
Files Included
1 downloadable file:
Downloaded: 36 times
Loading comments...