This folding bow stand should fit most recurve bows. You will need to print five copies of the tripod pole file (three for the legs and two for the neck of the tripod). Print the rubber foot end file with flexible filament to prevent the tripod from sliding on smooth surfaces. No glue is required to hold the tripod together except for the rubber foot ends.
Print Settings Printer: FlashForge Creator Pro Rafts: Yes Supports: Yes Resolution: 0.2 or higher Infill: 20% or higher
Notes: I recommend printing each part with at least 20% hexagonal infill and three perimeters in order to make sure that the parts are strong enough to support the weight of a bow.
Loading prints...
Recurve Bow Stand
Creative Commons Attribution-NoDerivatives
You can download, share, and use commercially, but you cannot change the material in any way or use it to make something new.
Licensed under CC BY-ND
Loading comments...