Summary I wanted to build a wolfstock style delta-bot, using Makerslide linear slides. But, I wanted to run the belt through the inside of the Makerslide for a cleaner look. This is still very much a work in progress, I'm currently working on completing the design and building the printer. I'm posting a build log on my blog: http://andy-projects.blogspot.com/2013/12/delta-bot-build.html http://andy-projects.blogspot.com/2014/01/delta-bot-build-part-2-belt-tensioners.html http://andy-projects.blogspot.com/2014/01/delta-bot-build-part-3-effector-rods.html http://andy-projects.blogspot.com/2014/04/delta-bot-build-cooling-fan-magnetic.html 1.1.2014 Update: -added belt clip, bolt to back of makerslide carriage -added belt tensioner to idler bracket -added tensioner arm 1.15.2014 Update: -Added carriage mount for rod ends -Added platform (intended for budaschnozzle but lots of mounting holes for anything) -added rod sleeve (for reinforcing end of carbon rods) 1.18.2014 Update: -updated platform and rod carriage mount to improve fit with traxxas rod ends 1.19.2014 Update: -updated platform and rod carriage mounts to allow better clamping of traxxas rod ends including variability in rod end center width 3.19.2014 Update: -added shroud for 40mm fan -added bowden tube mount for Budaschnozzle -added 5mm spacer for Budaschnozzle -added platform for magnetic bearings -added carriage mount for magnetic bearings 4.03.2014 Update: -added M5 threaded rod end caps for magnetic bearings 9.8.2014 Update: -added upper and lower braces to stiffen structure. 5.15.2016 Update: -added new versions of the platform and sliders to give more clearance to tie rod ends -added improved fan shrouds, two versions 12.26.2016 Update: -designed RAMPS mount to neatly attach RAMPs and Arduino to bottom of platform. I added this as a new thing: http://www.thingiverse.com/thing:1997781 -added improved fan shroud -added mount for 12mm diameter inductive or capacity proximity sensor for auto-bed leveling Post-Printing