This is the dragon that my 9yr old daughter made on 3D Slash (https://www.3dslash.net/index.php). It was her first time using it. It is amazingly easy.
I printed a family of these dragons for her. She is going to colour them in with some colourful permanent markers. She said it was OK for me to uploaded it here so others could make little dragons too.
I printed it in PLA at 205 degrees on a 55 degree bed, using 20% infill and 0.05mm layers. I scaled it down a bit to 4cm. It does need a fair bit of support, because she doesn't know about that aspect of 3D design yet. (Sorry that I haven't cleaned them up that well. I didn't realise how rough they where until I looked at the close up photos.)
Loading prints...
Talia's Dragon
Creative Commons Attribution-NonCommercial-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, with attribution and under the same license.
Licensed under CC BY-NC-SA
Files Included
1 downloadable file:
Downloaded: 52 times
Loading comments...