This is a fidget spinner that takes 22mm by 7mm (inside 8mm) bearings commonly used in skate boards, and scooters. It uses 5/16"-18 nuts for weights. The cap is a modified cap design from https://www.thingiverse.com/th... The design on the caps is the Halifax Robotic Logo.
Printed on Geeetech Prusa I3 M201
40-50% infill
any layer height
only support on caps
Caps must be printed flat side up or the design in the middle will most likely get mushed together
Loading prints...
Fidget Spinner
6
likes
2
collections
Tags:
Creative Commons Attribution
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given to the creator.
Licensed under CC BY
Loading comments...