Hictop controller cover EFI shield, Was getting electrical interference from the controller card onto the sensors.
This was causing erratic print moves, sensors to fail including the filament run-out sensor and the SD card to display garbage in the menu.
Print using a Conductive PLA. OR print with non-Conductive PLA and cover the inside perimeter with single layer of Aluminum Duct tape to form the EFI Shield, make sure you cover at least one mounting screw stand off to allow a grounded shield.
A Newer Version of this case is located https://pinshape.com/items/542...
Loading prints...
Hictop 3DP11 Controller cover EFI Shield
1
like
1
collection
Tags:
Creative Commons Attribution-NoDerivatives
You can download, share, and use commercially, but you cannot change the material in any way or use it to make something new.
Licensed under CC BY-ND
Files Included
1 downloadable file:
Free download - login required
Downloaded: 26 times
Downloaded: 26 times
Loading comments...