So i decided to make an RC-Benchy boat. Its printed with 25% infill ABS I printed it on my regular prusa printer and my D-bot. I glued the parts with ABS-slurry (A cup of Acetone and some abs filament for glue) I also used the slurry and applied it to the body to make it waterproof, 2-3 layers. There is one thing i would have done differently then i assembled the motor DO NOT use a glue gun, buy some epoxy-glue instead. I have some small leakage from the motor, so i removed all the glue and used ABS-juice to glue those parts also, but epoxy would have been a better option. I also integrated the support for the servo in the hull.
The parts I have been using is these:
- Rc-controller - https://goo.gl/qMHYCG
- ESC - https://goo.gl/7bu7ou
- Servo - https://goo.gl/igrLKy
- Steel shaft for servo - https://goo.gl/bGjfY
- Water proof plastic organ sleeve - https://goo.gl/X2DQ3i
- Lipo battery - https://goo.gl/Sz3hNR
- Lipo battery if not shipping to your country - https://goo.gl/1NdsGF
- Battery charger - https://goo.gl/ARW9yc
- Jet motor - https://goo.gl/6TM7CJ
- Epoxy-glue - https://goo.gl/wux3mr
- XT-cable converter https://goo.gl/KfVtNN
- 3 mm inner diameter sillicone tube - https://goo.gl/1QEdMs
- Tools: 3D-printer - https://goo.gl/VTXWFa
- Solderiron - https://goo.gl/SE2Kiz
- Solder helpinghand - https://goo.gl/nwfH0x
- Cutting Plier - https://goo.gl/nwfH0x
Build instructions here:
- https://www.youtube.com/watch?...
- Instructables step-by-step guide: http://www.instructables.com/i...
- In action:
Loading prints...
RC Boat 3DBenchy
Creative Commons Attribution
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given to the creator.
Licensed under CC BY
Loading comments...