Our daycare had gotten a tractor and trailer for free but without the split to hold them together. I measured and designed my take on a split, trying out a print-in-place technique and it worked perfekt. All you need extra is a spring.
I printed it at 100% infill to make sure it was strong enough, especially the print-in-place part. Also print it horizontally as shown in the picture to get a better chance of the tiny rotating pin actually rotating and make the print stronger. It prints in about 7 hours plus 15 min for the spacer.
Loading prints...
Split for toy tractor and wagon
0
likes
0
collections
Tags:
Creative Commons Attribution-NoDerivatives
You can download, share, and use commercially, but you cannot change the material in any way or use it to make something new.
Licensed under CC BY-ND
Files Included
2 downloadable files:
Free download - login required
Downloaded: 22 times
Downloaded: 22 times
Loading comments...