Summary Here is a remix version of my quintuple M14 Hex Nuts spinner. This one is holding 6 standards 608 skateboard ball bearings (Ø22mm), 1 in the middle and 5 on the outside. Good inertia and around 1min of spinning (depend on your bearing). This spinner is lighter than my M14 nuts spinner version but the gyroscopic effect is very nice ! Hole diameters is Ø22.1mm for good bearings mounting. 7mm wide for perfect balance after bearing assembly. I printed it using Blue glow in dark ABS for an amazing show in the dark. Stop using your pen clicker and start hand spinning ! Print Settings Printer Brand: CEL Printer: Robox Rafts: No Supports: No Resolution: 200 microns Infill: 50%
Loading prints...
Fidget Hand Quintuple Spinner / Ball Bearing Holder
Creative Commons Attribution-NonCommercial-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, with attribution and under the same license.
Licensed under CC BY-NC-SA
Loading comments...