Summary I designed this case because I was not happy with the pop on versions found on various sites. The Front and mid sections snap together around the Ipad. The Back piece I have included is plain, but you can customize this however you wish to give your Ipad a different look. I will upload different custom backs in the future. The layer height I used to make my own is 0.1 mm. To get the best possible print, place the outside exposed flat edge to the printer bed plate. Leave a comment or suggestions for improvement. Print Settings Printer Brand: Ultimaker Printer: Ultimaker 2 Rafts: No Supports: No Resolution: 0.1 mm layer height Infill: 100%