A twisting tower standing on a very unnatural hill. You can print the tower and the base separately, or whole thing at once. Either way no supports are necessary. I would recommend printing the tower slower and with lower layer height. Also for the stairs it's recommended to use higher infill to support the steps, and/or many top layers.
My print with 15% infill and 4 top layers had some small gaps.
Loading prints...
Twisted Tower
87
likes
63
collections
Tags:
Creative Commons Attribution-NonCommercial-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, with attribution and under the same license.
Licensed under CC BY-NC-SA
Loading comments...