This is a very simple and minimal pcb Holder. 

Assembly is very simple. Only need a 5mm Allen wrench and phillips screwdriver. 

Adjust the width by moving the bases along the axis/shaft.

Adjust the orientation with two knobs. 

With supports for soldering wires!!! Maximun pcb: 170 x 220mm

Bill of material (BOM):

• Hexagonal Nuts M6 x2 un.
• Aluminiun, Steel o wood Shaft or similar Ø12.7mm x 250mm of large.
• Allen Bolt M6 x 30mm x2 un.
• Rubber or NBR rope of Ø5,5mm (5cm)
• bolt parker Ø3mm x 12mm (x4 un.)