This is a small-ish, 130mm wide candy dish that I made for Halloween. This is my first ever attempt at using Blender, so... be kind :)
Supports: Yes
Resolution: 0.1 - 0.3
Infill: 10%
Notes: This needs [Supports Everywhere] turned on, especially for the lid. This will look best if you can print it in orange. Then, for the lid, you can pause the print as soon as the last layer of the pumpkin itself is printed and then switch to green filament. Slicing in Cura 2.6.1 at 0.3mm layer height, the pause was at layer 76, but your mileage may vary, so double check for yourself to be sure.
Loading prints...
Pumpkin Candy Dish
7
likes
0
collections
Tags:
Creative Commons Attribution-NoDerivatives
You can download, share, and use commercially, but you cannot change the material in any way or use it to make something new.
Licensed under CC BY-ND
Files Included
2 downloadable files:
Free download - login required
Downloaded: 100 times
Downloaded: 100 times
Loading comments...