I just started fixing my old helis again since I wanted to try and get back to flying. I haven't touched them for over two years and while looking them over I found that the battery mount on my old 450 V2 was broken. Needless to say I decided to design a new one for it. But I also decided to make it a tiny bit longer and also add a strap loop. The original didn't have this and every time I took off my battery the strap was always falling on the ground. So this keeps my strap in place just like on my 405 Pro heli. Here's a video of this mount.
Just plain old PLA
200 mm layer height.
36 percent density
Loading prints...
450 V2 Helicopter Battery Mount
Creative Commons Attribution-NonCommercial-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, with attribution and under the same license.
Licensed under CC BY-NC-SA
Loading comments...