At last, a use for a dead rat. As a doorstop.
Should work with most doors, depends on the gap. The thin end of the tail is about 4mm. I printed mine at .3mm layer height with 3 perimeters, 10% infill and four top layers. I used support but you may be able to print without.
If it slips on the floor try gluing a strip of sandpaper on the bottom for grip.
Loading prints...
Dead Rat Doorstop.
0
likes
0
collections
Creative Commons Attribution-NonCommercial-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, with attribution and under the same license.
Licensed under CC BY-NC-SA
Loading comments...