Description
MOVED to https://www.thingiverse.com/th... due to PINSHAPE payment issues. Feel free to tip there. Thanks!
Replacement gear for VW Touareg tailgate/boot latch.
Print Settings
Printer:
Frankenstein
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2mm
Infill:
100%
Notes:
As this part is quite small and intricate, I'd recommend printing slower to avoid the hotend pulling on the part at higher speeds.
You may need to file some of the edges to ensure a smooth and clean fit but it also depends on how well you can print the part.
I had better results with the overhangs using 0.2mm layer heights.
PLA was the end result. I tried PETG but it's quite soft compared to PLA and tends to get pulled around a bit.
I'd recommend PLA or a nylon based (the original part is nylon) filament although I haven't personally tried nylon.
Recent Prints (2)
More from this category
Smart LCD Case Stand Alone version
A stand alone LCD case for the RepRap Smart LCD with SdCard reader
SD Card Flash Drive Holder
by Gpasteve
SD Card/ Flash drive holder that can be mounted to a 3d printer, a desk or a shelf .
Apple Pencil with Smart Cover clips for iPad Pro
by vova_chmarak
Clips for iPad Pro with Smart Cover and apple pencil
Flexible covid ear saver (13 to 24 cm long)
by imakina
Flexible ear saver 13 to 23 cm long. Only 1 gram each piece.
Arduino Pro Mini Holder
by dTom
SummaryUpdate V3, More secure to hold the Pro mini For Plotclock on Note 2 (http://www.thingivers...
Comments (4)
Sign in to leave a comment.
Hi, as per Mumfrey, the design is not able to be purchased. "Purchasing is temporarily disabled due to a server issue".
Hi PierPrint, do you have this available for purchase anywhere else as it seems like pinshape's ability to purchase is broken at the moment and has been for a week or so?
Hi, sorry I seemed to have missed the notification of your message. This file is not hosted anywhere else. Have you tried the purchase again?