I really liked the filament holders that used bearings for the spool itself to roll on but always thought they were inefficient since they always involved large prints and only held a single spool. I set out to fix this using what I had laying around. This system uses a series of spacers and clips to hold multiple spools on 2x8mm smooth rods (the cheap kind from the hardware store not the nice kind used for printer axis)
Credit to LittleDangerous for the C clip
Loading prints...
Filament bearing/rail system
94
likes
5
collections
Tags:
Creative Commons Attribution-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given and your contributions are under the same license.
Licensed under CC BY-SA
Loading comments...