need a rail raiser on your srs silverback here it is.
this also gives a other look for your srs silverback. it´s printed on my ender 3 the railrasier and rail was printed in 45 angle wiht werry little support all 3 sizes is in this packet you will need 8pcs m4 x25 screws 8pcs m4 nuts 14pcs m5 x4 counter sinks i printed in pla pro from spectrum
Loading prints...
Srs Silverback Front and railraiser
2
likes
2
collections
Tags:
Creative Commons Public Domain
The creator has waived all rights to the work. You can copy, modify, distribute and perform the work, even for commercial purposes, without asking permission.
Licensed under CC0
Loading comments...