For my Children's Hospital Christmas Tree Project I wanted to hang lithophanes from the Christmas tree. With this clip, you can!
To make your lithophane:
- Drag a picture into Cura
- Base 0.8
- Height 2.7
- Width to 70
- Dark is Higher/Light is lower
Then print it out and slip it in. You want the lithophane to hang down. The cap will snap on after to keep everything looking good. Trim off any excess.
Loading prints...
Lithophane clip for a C7 Christmas light
19
likes
10
collections
Creative Commons Attribution-NonCommercial-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, with attribution and under the same license.
Licensed under CC BY-NC-SA
Loading comments...