Free
I made this to accommodate the cork-heater-glass setup I have on my printer. I'm using two sheets of 4mm cork, a sheet of 2mm glass, and the heater PCB (1.5mm) sandwiched between them. If you need to tighten its grip a little, a quick hit with a hair dryer makes it malleable enough to set where you need. I've also included the .blend for those who may want to alter it to suit their needs. Due to pinshape's system I was forced to give it a faux extension. Just remove the .txt and open it with blender
Loading prints...
Glass Bed Clip
2
likes
0
collections
Tags:
Creative Commons Attribution-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given and your contributions are under the same license.
Licensed under CC BY-SA
Loading comments...