This is an ankle sock holder much like the paper inserts when they are first bought. This will help keep those socks from stretching/shrinking and keep them organized all at the same time.

This was designed based off the paper holder that come with socks with first bought. I made some design choices that will reduce the amount of filament needed and make the success rate of this print as high as possible.

===I printed the with the following settings: [Anycubic I3 Mega]===

Layer Height: 0.3mm

Top Layers: 3

Bottom Layers: 3

Perimeter Outlines[shells]: 3

Infill %: 10

Infill Pattern: Triangle

======================

*These settings are good for fast prints. I set my printing speed at 100 mm/s. This isn't good for everyone so do as your printer allows. 

*If your printer bed has trouble with prints sticking to the bed, consider using a raft for this one. Since there is a lot of movement in this print, being that it is almost 8" long, variations in temperature of the print layers can cause lifting from the bed.