i designed this phone stand to be used horizontally and designed in Tinkercad, although i'm still learning to design i thought i'll put it out there to see if anyone would like to print it, i have printed it in the shiny bronze at 60 mms 0.01 layer height 200c nozzle and 60c bed, i printed it standing on it's side for best results, it took about 2hr 55min it's a 35 degree angle for viewing horizontally and as you can see in pics my logo is under viewing platform, you can alway take that off by going to tinkercad and just placing a 1mm piece of square on top