2025 / 03m / 26d
I make a bracket for Fanatec Wheel Bases.
https://pinshape.com/items/128...
2024 / 11m / 8d
It's been five years since I designed this, and I decided to share it completely free.
I hope more people enjoy my paddle shifter.
Inhanced body updated 2021.03.01
ABS / Infill 80%
*IMPORTANT NOTE
DO NOT tighten the two screws inserted into the body!
I desined for 320mm~330mm Steering Wheel.
Because it is designed to be tight for durability, You need sandpaper.
When the magnet is installed to collide, It improves control feelings.
Items Required:
Micro lever switch x2 125V 1A 3 Terminals Momentary 13mm Lever Arm Micro Switch Black KW10 ...
Circular neodymium magnets x2 8x5mm ...
M3 Cap socket screws 1x 35mm 1x 25mm 2x 12mm 4x 10mm
M3 Nut x8
Wrapping Wires ....
Zero Delay LED Arcade MAME Encoder USB To PC 5Pin Joystick PCB Board+Cables ....
or you can use another many joystick pcb.
Instead of PCB, also use Arduino Pro Micro. ....
...
If you use Thrustmaster T300 or T500, use YipZone's Circular base ...
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License. ...
Loading prints...
DIY WRC Magnetic Push-Pull Paddle Shifter for Rallysim
Creative Commons Attribution-NonCommercial-NoDerivatives
You can download and share as long as you credit the creator, but you cannot change the material or use it for commercial purposes.
Licensed under CC BY-NC-ND
Loading comments...