Simple rope bridge for table top gaming. Every two boards count as one square. Bridge is considered 2 squares wide. I printed the rope bridge part out of flexible TPU so to get a bit of droop and not be rigid... But could be printed in PLA as well.
In the picture I have it across a river. However I like to use this across a chasm, or a lava stream. I then get my players to fight mid bridge and make regular balance checks as to not fall off (since a rope bridge would sway quite a bit with a fight going on, on it).
Loading prints...
Rope Bridge 28mm
3
likes
3
collections
Tags:
Payment system coming soon!
Creative Commons Attribution-NonCommercial-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, with attribution and under the same license.
Licensed under CC BY-NC-SA
Loading comments...