This is a 3d printed, radio controlled bulldozer. It is about 200 hours of printing time, zillions of screws, bearings and so on. It has 2 motors, one for each track. And, it has 2 servos lifting the blade up and down. The whole project is CC4-by-nc-sa.
How does it look like: https://www.youtube.com/watch?v=pU6fe7RiBuI
The STLs here contain just the driver cabin. The full set of STLs and a manual for assembling can be found at Github:
https://github.com/pstimpel/caterpillarbulldozer/
Print Instructions3 shells horizontally and vertically, 10% cubic infill for most of the parts, PLA, most parts print without support needed
Loading prints...
Caterpillar Bulldozer, RC
Creative Commons Attribution-NoDerivatives
You can download, share, and use commercially, but you cannot change the material in any way or use it to make something new.
Licensed under CC BY-ND
Loading comments...