These struts are designed to stabilise the Anet A6 and to prevent it moving on it's bench.
I found that after adding more tension to the Y Belt that the whole printer would "flex" forward, to fix this I added these 8mm threaded struts which hold the printer in the correct position at all times.
These have saved me a fair bit of bed levelling by stabilising the positions of the uprights relative to the Y axis front belt plate.
Each 8mm threaded strut is about 40cm long but I would advise buying a 1m length and cutting to the right length in place after bolting everything up.
Loading prints...
Anet A6 Stabilising Struts and Base Clamp
Creative Commons Attribution-NonCommercial-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, with attribution and under the same license.
Licensed under CC BY-NC-SA
Loading comments...