Description
Designed this for my Pi-hole setup. Uses the Pi Zero W and a cheap chinese 3.5" PiTFT. Need an HDMI adapter and usb pcb pieces, also one 6x6x5mm tactile button and 3mm led. I stress tested it with a good overclock and it doesn't get above 60 so cooling isn't a issue but these seem to do pretty good without much cooling.
More from this category
SDSBTOTO | Modal Receh WD Sultan
by SDSBTOTO
Siapa yang tidak suka bermain togel? Bagi sebagian orang, bermain togel adalah hobi yang menyenan...
MKS gLCD 12864 Case
by Patrick Li
MKS gLCD 12864 Case V3, Fix angle of bottom to 90 degree
Post-It Note and Pencil Holder
by LogixNinja08
A MLG post it holder that holds ... you guessed it ... cocain- I mean post its. ...
OpenRC Calibration Cube
by DanielNoree
Before you start printing the OpenRC F1 that uses pockets to fit the small M3 nuts and see if you...
CluchCoCloneV2
by Froongia
Join us in the journey of redefining what's possible. ClutchCo: 3D printed perfection, designed f...
vacuum pod per Biesse rover
by steveandsong
vacum pod per Biesse rover 346 e altri modelli
Comments (4)
Sign in to leave a comment.
Thanks! Just find it to make a slim case! Exellent! any printing settings i need to know?
i love it ;)
Thanks