Jason Smith
@PrintSomething
I like to design and create with my Davinci Pro printer. I also like to mess around with Raspberry Pis too.
Da Vinci X and Y Carriages Version 3
A whole new setup for the X/Y axis for the DaVinci, Carbon Fiber rods for the X axis, lighte...
Manscaped Lawn Mower 3.0 Guards
Made up some longer guards for the Manscaped Lawn Mower 3.0. The smallest one is the same a...
Fishing Line Reel Tool
A quick little tool to hold tension on your line to run new line. Will need some M3 bolts a...
Da Vinci Spool Mount Inside Back
Spool mount to go inside the back on Machine, uses LM8UU bearings and 8mm shaft cut to size
MKS Gen L Stepper Driver Fan Mount
A quick design for some 30mm fans for the MKS Gen L stepper drivers
Da Vinci Bed Level Screws
Bed level screws, need m3 brass inserts 3mm long x 4mm diameterAdded some simple locking knobs to...
Da Vinci New Design X and Y Carriages
New design, will gain about 20mm of Z height, will not work with the factory board. You can...
Wire Clips
Simple wire clips, can be super glued to manage your wiring. Added some new ones.
Da Vinci Logitech C310 and C270 Camera Mount
Simple camera mount for the Logitech C310 camera should also work with the C270. Bolts to t...
Da Vinci Inside Spool Mount
You will need a 8mm rod about 85mm long, 1 LM8UU and 1 LM8LUU for the shaft per spool holder. Wil...