This is 2 parts to make printing easier. I make a lot of GoPro mounts but I was never 100% happy with them, too tight, too loose, holes too small.... So I completely redesigned this one and I may be updating my other models with this connector. Also, I found something important for printing thin walled items like the GoPro mounts (fingers), it's important to only have 2 perimeters and then 100% infill. I use to print with 4 perimeters but it turns out that is way too weak because of layer adhesion. See this thread for the full story http://forums.reprap.org/read.php?262,357700
Loading prints...
GoPro handle
Creative Commons Attribution-NonCommercial-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, with attribution and under the same license.
Licensed under CC BY-NC-SA
Loading comments...