My attempt at an accurate movable terminator hand. I made this in Sketch up and models must be imported in inches to be the correct size. They are named as close to actual anatomy as I can figure to help in assembly. Also 1 is thumb 2 index ect.. 1/8 in rod cut to 5/8 in pieces will hold most of it together pretty tight or you can use screws and run cables through the pulleys to make it move if you want. I am working on simplifying the construction of the model still.
For example a file labeled 2345 would be the same for index2 middle3 ring4 and pinky5 so you would need 4 of those. If there is more than one number in a file name it is a piece that is the same for multiple fingers. Example to assemble ring finger (4) you would need 2-4_proximal_phalanx, 2345_meticarpal_phalanges, 4_medial, and 2345_distal_phalanx for the main 4 pieces of the ring finger
Loading prints...
Terminator Arm (inches)
Creative Commons Attribution-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given and your contributions are under the same license.
Licensed under CC BY-SA
Loading comments...