Introduction:
The kit includes roof racks, crossbars and roof rails. The guide rail design makes it easy to adjust the position back and forth. There are two versions of the roof rail. One is installed with screws and the other is installed with double-sided tape. (The distance between the roof screw holes is 116mm wide and the length is 88.7mm. Twelve M2*6 and four M2.5 screws are required for installation.)
About printing:
The main body is divided into multiple parts to facilitate printing. Then glue it together. In addition, "one piece" is prepared, which can be completed at once.
Reminder: Using "simultaneous printing" to print small objects can reduce heat accumulation.
Thanks for attention.
Loading prints...
rc car roof rack kit
Creative Commons Attribution-NonCommercial-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, with attribution and under the same license.
Licensed under CC BY-NC-SA
Files Included
11 downloadable files:
Loading comments...