Cylon Raider from BSG. 

Main body of the cylon and wings is a single print file. The only parts not attached that need glue later are the engine nacelles. I suggest printing with a brim for the 3 engine nacelles to safely stick to the bed during printing. NO support needed. The sacrificial supports built in are more than good enough to hold the model for print as long as you don't shrink it. If you do resize down you will need supports.. 

I tried adding this file to thingiverse along with all the info on where the design took its cues from, but as usual, thingiverse took the upload but will not show for others.