A book that you can use to store your dice, markers, candy, etc. Blank cover without the skull included. Can store approximately six sets of polyhedral dice. See print settings below!
Height: 175mm / 7" Width: 125mm / 5" Thickness: 37mm / 1.5" Internal storage height: 30mm / 1.2"
I can adjust the size on request
Cover:
No supports needed
0.2mm layer height
2 walls
10% infill
To get a leathery look on the cover: Enable Fuzzy skin
Fuzzy skin Point Distance 0.4mm
Fuzzy skin Thickness 0.1mm (max)
(Fuzzy settings are the same in most slicers but results may vary with printer model and outer wall print speed. Slower is better)
Pages:
No supports needed
0.24mm layer height
3 Walls
10% infill
Loading prints...
Skull Book for dice or candy - Snap close, no magnets needed
Creative Commons Attribution-NonCommercial-NoDerivatives
You can download and share as long as you credit the creator, but you cannot change the material or use it for commercial purposes.
Licensed under CC BY-NC-ND
Loading comments...