Finalement used: 1018mm (~0.15$) PLA
Print time: 16min
Layer: 0.2mm
Supports: Yes
Infill: 20%
I had to file the material a tiny bit but i got it just the right pressure to hold bits.
You can buy a single bit holder from DeWalt but they sell it 20$ and it's a single bit holder. Why not make our own. ;-)
VERSION 2: After using it quite a lot. the plastic worn down and the bits would slip out. I upgraded the design by adding 2 tabs to fit with the bit lock groove. When installing it, I put a peace of dense foam under the tabs to help with the spring. (See picture)
Loading prints...
Impact Driver Bit holder - Double bit holder
29
likes
16
collections
Tags:
Creative Commons Attribution-NonCommercial-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, with attribution and under the same license.
Licensed under CC BY-NC-SA
Loading comments...