SummaryThe layer cooling fan was designed for the ORDbot Hadron machine but could be used on any machine with a flat mounting plate.
For the hinge pins use a section of 1.75mm filament.Print SettingsPrinter: ORD Bot HadronRafts: NoSupports: YesResolution: 0.2Infill: 50%Notes: designed for use with E3D hot end, LJ12A3-4-Z/BX Inductive Proximity Sensor.
Hardware:
2x
#6-32 Square Nuts.
2x
#6-32 x 3/4" SHCS.
Mounting:
2x
M4 X 8 SHCS.
For the layer cooling fan duct I just uses some two sided sticky tape and that works fine.
Loading prints...
E3D Hotend Mount with z-probe mount and cooling fan for ORDbot H
0
likes
0
collections
Tags:
Creative Commons Attribution
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given to the creator.
Licensed under CC BY
Loading comments...