Another take on a drive block for the extruder of the Zortrax/Wanhao D6/Monoprice Ultimate clonage for flexible filaments.
Version 2 has a very tight fit for the 10.8mm diameter, 38 tooth Robotdigg Filament drive gear 4 flat shaft for nema17 stepper (RDGFDB) and the Micro-swiss lever for the Wanhao D6. The original D6 drive gear will also fit. You may have to sand the inner diameter a little. Clean up the print by drilling through the filament guide and smoothing the upper entry. I printed this in PETG.
I can finally print large projects in Ninfaflex on the Wanhao D6.
Loading prints...
Wanhao D6/Monoprice Drive Block for Flexible Filaments
Creative Commons Attribution-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given and your contributions are under the same license.
Licensed under CC BY-SA
Loading comments...