Summary
Had an unintended sudden deceleration and lost one of the rubber feet in the back of my Mavic Pro. As I attach larger legs there I needed a replacement. However, DJI doesn't make these available at this point in time outside of repair. So I eyeballed the dimensions as good as I could and printed these in Ninjatek Cheetah that I had around. Little bit softer compared to the originals but this filament is very tough.
Print Settings
Printer:
Monoprice Ultimate Rafts:
No Supports:
Yes Resolution:
0.150 mm Infill:
100 Notes:
Ninjatek Cheetah, 80C PEI Bed, 220C, Fan 40%, extrusion 0.9
Loading prints...
Replacement rubber feet for DJI Mavic PRO
0
likes
0
collections
Creative Commons Attribution-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given and your contributions are under the same license.
Licensed under CC BY-SA
Loading comments...