A simple printable part that is attached with glue, contact cement was used, to a board. Bolts can be added for additional support but hasn't seemed necessary. The wood was scrap from a shipping crate but nicer, pre-cut, 12 inch diameter boards can be purchased from most chain hardware stores (I've seen $10-15 USD).
Printed with:
- 0.25 layer thickness
- 1.2mm perimeters
- 0.75 bottom layers
- 1.25 top layers
- 3D infill 20%
Please make sure the material is well laminated before using. Flaws in the construction could lead to injuries. Not recommend for hardwood floors but a few coats of Plasti Dip might be sufficient. Grip tape is optional for rough wood but recommended for the smooth store-bought pieces.
Loading prints...
Balance Board
Creative Commons Attribution
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given to the creator.
Licensed under CC BY
Files Included
1 downloadable file:
Downloaded: 51 times
Loading comments...