A friend asked me to design and print him a few caps to keep the dirt out of his CO2 gas refill devices - and to keep them from discharging while in his pocket.
I took a few measurements of the device, which takes a standard 12g CO2 capsule and has a simple valve and pressure gauge, and designed this simple cap (with a few added dimples to make it look the part). The Cap has a hole for inserting paracord or similar (4mm diameter) to allow the cap to be tied to the charger device.
There exist a number of versionf from various manufacturers, but the product this one was measured off of is this: https://airsoftpro.cz/en/airsoft-guns/sniper-rifles/other-grenades/co2-plnicka-airsoftovych-granatu-s-manometrem-detail
Loading prints...
C02 Gas Airsoft Grenade Charger Cap
Creative Commons Attribution-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given and your contributions are under the same license.
Licensed under CC BY-SA
Loading comments...