So simple to build ... first I cut out the nostrils from the mask enough to fit the PIXY CMUcam5 lens through. Then I did four little drops of Gorilla glue on the edges of the PIXY CMUcam5 to the mask. Then I drilled a 10mm hole in the bottom of the mask chin to Gorilla glue a pin through to the "U" tilt bracket. Then after assembling the Pan&Tilt it was easy to mount the face mask. My next move is to find a thin plastic hollow skull about human size to fill in behind the mask, then I can give it draping black rags to hang down below and mount it on a short 1" PVC pipe for table top center piece, or any other length 1" PVC pipe to make it anything from 120cm to 240cm tall ghost.
Loading prints...
Halloween Mask Pan&Tilt with a PIXY CMUcam5
Creative Commons Attribution-NonCommercial-NoDerivatives
You can download and share as long as you credit the creator, but you cannot change the material or use it for commercial purposes.
Licensed under CC BY-NC-ND
Files Included
8 downloadable files:
Loading comments...