This is a simple earring holder design I came up with for a friend. There are two designs, the main holder and lower tray are simple single piece prints. The upper, mid and lower body are a more modular design in case you need more or less. These are located with 1/8" dowel pins ~1/4" long and is glued together. I found a .3 MM nozzle worked better than a .4 when printing this, but a .4 will get the job done. Just make sure to watch your number of retractions! Also, you will need some small head nails to hold the unit up to the wall.
For mounting the center holes are 7.75" apart.
Check out the video on it here:
Loading prints...
Earring Holder
Creative Commons Attribution-NoDerivatives
You can download, share, and use commercially, but you cannot change the material in any way or use it to make something new.
Licensed under CC BY-ND
Loading comments...