The clamp is suitable for use by small cameras like Hero or Yi 4k + and other similar ones. You can also use smartphones for shooting.
The clamp can be mounted on the shelf or edge of the table. Using the ball head - the viewing angle is not limited. Also suitable for other devices for installing cameras.
I used tubes with a diameter of 8 mm, a wall thickness of 1 mm. Anodized aluminum. Threaded stud - M5 length 110 mm. Rubber substrate can be printed with soft filaments.
Some parts have to be glued together, but I'm sure you can do it :) In principle, it was possible to make clamps and thinner, but I was reinsured and made a margin of safety. In the video, I showed the stages of assembly of some parts.
For the options of suitable ball heads, see below.
- https://goo.gl/5hVXyZ
- https://goo.gl/v87HJE
- https://goo.gl/19m1nn
- https://goo.gl/DGP4b4
- https://goo.gl/ZMbHR2
Loading prints...
Clamp for vertical use. Photo and video shooting
Creative Commons Attribution
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given to the creator.
Licensed under CC BY
Loading comments...