I needed a small flower pot for my succulents. But I wanted something more fancy than normal. So I designed this three piece fancy little flower pot.
Printing the pot and trivet can be done easly without support. But the stand is a little bit tricky. I worked for me to use tree support instead of normal support. You can use a layer height of 0.2mm (or smaller) for everything.
Loading prints...
Fancy Flower Pot
14
likes
3
collections
Tags:
Creative Commons Attribution-NonCommercial-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, with attribution and under the same license.
Licensed under CC BY-NC-SA
Loading comments...