@EEL
I post things here that I've made and found useful, in hopes that you will too.
Filament Spool Cable Reel
by EEL
If you've got piles of nice filament spools that you don't know what to do with, try re-using the...
Rode Blimp ORTF Shockmount
by EEL
These supports are to allow you to position two cardioid microphones inside a Rode Blimp at ORTF ...
Battery Holder for 4s 26650 Pack
by EEL
This is a battery holder for a 4s pack of 26650 size cells. It consists of 3 parts.... a case, an...
Lathe Tool Holder
by EEL
This is a small lathe tool holder for boring bars and cutters. The largest hole is for a 20 mm bo...
Anderson Powerpole Shroud
by EEL
This is a shroud for the 15/30/45 amp series of Anderson Powerpole connectors. There are two file...
Tumbler Drum
by EEL
This drum has ribs inside to help toss the media each revolution. The drum is about 8.2 in wide a...
ORTF Clippy Mount
by EEL
The goal of this design is to create a small, lightweight ORTF holder for the small "clippy" mics...
8 inch Telescope Mirror Mount
by EEL
This is a mount and retaining ring for an 8 inch diameter telescope mirror. I recommend printing ...
Microphone Windjammer Cage
by EEL
This cage is designed to be a support for additional coverings (spandex and faux fur) to reduce w...
Cable Splice Jig
by EEL
This is just a little jig to help splicing microphone cable (or other cable). The diameter is 0.3...
MixPre-3 Stand
by EEL
This is an angled desk stand for the Mixpre-3 to set on. You can stick anti-skid rubber on the fl...
Microphone Cable Splitter
by EEL
This cable housing was used to hide the solder connections between a 4 conductor mic cable, and a...