Dennis Berry
@dennis_berry
Retired engineer from Intel Corp. Now living the good life in Sun City. I can waste an entire day and then another one tomorrow.
USB Drive Holder - Round
by dennis_berry
Summary I've always been discouraged that manufacturers of whatever device it happens to be that ...
SD Card Holder - Round
by dennis_berry
Summary This is for you folks with fat fingers (like me). I've tried a few of the designs on here...
ProtoX Blade Guard
by dennis_berry
Summary The protector rings sit a little higher than some I've seen on here. May weigh just a fra...
Spool Holder
by dennis_berry
Summary Made for FlashForge Creator Pro back panel. Holds spools that have a slightly deeper hole...
Ride Height Gauge - Losi
by dennis_berry
Summary Ride height gauge measures 27mm for Losi 8ight-e 3.0/4.0. Drop the car from about 8-10" t...
Decorative Shelf
by dennis_berry
Summary The top measures approximately 6" X 9" and will just fit flat onto a stock Flashforge Cre...
Camber Gauge
by dennis_berry
Summary A typical setup for offroad RC cars is a negative one degree camber on the front wheels a...
Watercolor Palette w/brushholders
by dennis_berry
Summary You can lay your brushes down so if they drip, it's into a pan and not on your work surfa...
Designer Shelf w/Three Designs
by dennis_berry
Interchangeable front panels. Three designs available. Print the one you like and insert it onto ...
Small Birdie Shelf
by dennis_berry
Size is approx. 3" x 5" but designed in mm. It printed OK but I would scale it up in Simplif...
Jack Stand
by dennis_berry
It's better to store your RC cars with the wheels off the ground so they don't become missha...
Post It Note Holder Small Size
by dennis_berry
A simple holder which it makes easier to write on the Post It Notes.