Y xis calibration block for Creatr printers.
by Teneo Peto
Summary The y axis easily gets out of alignment on leapfrogs creatr. Mount this block on top of t...
Spring loaded extruder mod for Creatr dual exstruder -V5 final v
by Teneo Peto
Summary I made the excellent ninjaflex spring loaded exstruder mods referensed from eliscott02 a ...
Stabilising 12 mm top rail with 12 mm bearings for spring loaded
by Teneo Peto
Summary After seeing how much the original setup vibrates during printing. I made a version of th...
Low profile cable chain for lazy people - uppdated for sharper b
by Teneo Peto
Summary There are many great cable chains on thingyverse but i am, very, very very, lazy. I wante...
Spray templates
by Teneo Peto
Summary I needed to shipp some fragile goods so i made this template. Just glue it on a piece og ...
Wide stable y Axis guide bearing mounts for Creatr and Creatr XL
by Teneo Peto
Summary The right bearing is installed and its a massiv improvement in extruder carriage stiffnes...
dial holder for levelling Creatr and XL dual exstruder printer b
by Teneo Peto
Summary i have been fixing and improving my Creatr printer a lot. Every single time i take off a ...
Super uppgrades for Creatr and Creatr XLprinters
by Teneo Peto
Summary Uppdate 24-11-2015 ( I have uppdated the bearing blocks. https://youtu.be/QRKUzB4lhs4 Th...
Snap on fan holder for Creatr and XL - final version
by Teneo Peto
Summary i got tired of unskrewing the fans every time i wanted to get to my exstruders so here is...
Self Watering plant pot holder
by Teneo Peto
Summary Do plants die off as soon as you enter the room? Here is the solution for you. fill the b...
2 potmentiometer directional and speed control for motors
by Teneo Peto
Summary I am automating a table saw and need directional control with potentiometers so i made th...
DIY 4 facet drill bit sharpener = razor sharp awsome drill bits.
by Teneo Peto
Summary This is a jig for sharpening drill bits to 4 facet on a vater grindstone. Makes perfect 4...